Stûv 16-H Montageanleitung Seite 25

Positioning of the stove cover
Using the handles provided, place
the cover onto the stove [photo 1].
Centre the cut-out part in the cover in
line with the stove's smoke outlet.
Attach the cover with the 4 screws
at the front [photo 2] starting with
the screws at the back. To line up the
holes you could use a clamp (do not
scratch the cover).
The upper part of the cover has to
be connected with the stove: a bolt
is provided for this purpose [photos 3
& 4].
– remove the hexagonal screw from
the bolt [photo 3]
– swivel it 3/4 of a turn [photo 4] and
retighten the screw.
Alignment of the cover of the
stove with the base
Check the adjustment at the back,
along the depth and then laterally.
Adjust if necessary.
Using a size 10 key, screw the back of
the base to the stove from inside the
base [photo 5].
Adjust the front if necessary and screw
in the front of the base, again from
the inside of the base.
For assembly, refer to the installation
instructions for the Stûv 16-cube from
page 13.
1
3
5
7
2
4
6
8
instruction - installation base Stûv 16-H - 0710
en
25