Stûv 16-H Montageanleitung Seite 22

INSTALLATION
Unpacking
Please note !
The paint of the base is not oven-
baked and is therefore relatively
fragile. Handle the base with care
during installation.
List of contents
– 1 base (for 16/58 : ref 13010012,
for 16/68 : ref 13010013, for
16/78 : ref 13010014)
– 4 x M6x16 screws with hexagonal
head
Optional : outside air inlet for 16-cube
base :
– 1 air inlet duct
– 1 union
– 1 piece of flexible tubing
– 2 clamp collars
– 4 M4 nuts
Installation
Preparation of the support plate
and the base of the Stûv 16-cube
Unpack the Stûv 16-cube (see pages
8 and 9 of the installation instructions
for the 16-cube)
Take the support plate and the 4
adjustable feet.
Using a size 3 Allen key, remove the
plug from the air inlet and the flaps
at the front and back of the support
plate [photos 1 & 2]. These parts are
not used in installation.
Remove the packaging from the
base of the Stûv 16-cube [photo 3].
Using the screwdriver (T x 20 head),
unscrew the base from the wooden
palette [photo 4].
instruction - installation base Stûv 16-H - 0710
22
1
1
3
2
2
4