Conrad FHT 8W Bedienungsanleitung Seite 41

"An/Aus/Aut" (1) = ""On/Off/Aut" .................. Main display / Automatic mode
"Manuell" (2) = "Manual" .............................. Select manual operating mode
"Aus/An" (3) = "Off/On" ................................ "Aus" = switched off, "On" = switched on
"Status" (4) ................................................... Check the current status of the thermostat
"Anlernen" (5) = "Programme" ..................... Programme/recognise thermostat(s)
"Löschen" (6) = Delete ................................. Delete thermostat and make memory block available
"Grenzwerte" (7) = "Limit value" .................. Programme the limit value for the valve opening
"FS20 Aktivieren" (9) = "Activate FS20" ...... Select the FS20 transmission outlet function
"FS20 Adresse" = "FS20 Address" .............. Display and change the FS20 address
"FS20 Anlernen" = "Programme FS20" ....... Programme FS20 actuator to the "FHT 8W"
"Der Regler wird gelöscht" =
The thermostat is being deleted
"Speichern des neuen Grenzwertes" =
Saving the new limit value
"Speichern der Einstellungen" =
Saving the settings
"Speichern der neuen Adresse" =
Saving the new address
"FS20-Anlernbefehl wird gesendet" =
FS20 programming command is being sent
41