Adresse" Sub-Menu (= "Address"); Anlernen" Sub-Menu (= "Programme") - Conrad FHT 8W Bedienungsanleitung

"Adresse" sub-menu (= "Address")

• The following elements of the FS20 address are displayed in succession and can be adjusted with
the "+" and "-" buttons:
"HC1" (11) = House code part 1
"HC2" (12) = House code part 2
"AG" (13) = Address group
"UA" (14) = Sub-address
• The changes are only saved when confirmed with the "Menu/Enter" button after the last step, the
sub-address.
Note that both the address group 44 and the sub-address 44 are of special importance. If these are
set, the device will act as a master device and/or a function group will be addressed.

You can find information regarding this can be found in the operating instructions of
the different FS20 components.

"Anlernen" sub-menu (= "Programme")

• First the actuator to be programmed must be placed in programming mode. The actuator
instructions will describe how this is to be carried out.
• If you then select the "Anlernen" (= "Programme") menu item, the "FHT 8W" sends a command and
the actuator should be programmed to the radio channel.
37