Electrical Connection - STG-BEIKIRCH CDi EasyDrive/2 Bedienungsanleitung

Electrical connection

Before making electrical connection the separately supplied
control elektronics must be fitted to the motor gearbox unit.
Afterwards screw on the also separately supplied
connector housing, make the corresponding notches at the
cable entry and pull the plug housing over the connector
cables. Then connect the wires of the connecting
cable to the screw terminals of the 8-pin plug according
the connection example. Screw together the connector
housing and place it on the electronic housing.
Connection example for up to 4 CDi EasyDrive/2 drives at a window
04/13424999486
CDi EasyDrive/2 (drive 1)
CDi EasyDrive/2 (drive 2)
CDi EasyDrive/2 (drive 3)
CDi EasyDrive/2 (drive 4)
Chain drive CDi EasyDrive/2
Motor gearbox unit
Control electronics
Connector housing
Cable entry
power cable
(not included)
power cable
6
connection cable
4
connection cable
4
connection cable
4
21