Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Procedure for Setting the Slide Switch
W
Ｗ
Ｎ
<Slide switch position on the MC-R433U rear panel>
1.
Ensure that the slide switch is set to N.
The W position is for use by service personnel only. The
user should not use this position.
Procedure for Attaching the Drive
Storage Cover of the CD/DVD Library
1.
Secure the cover with the screws that were removed.
"Procedure for Opening the Drive Storage Cover of
the CD/DVD Library" on page 3.
Procedure for Closing the CD/DVD
1.
Close the door and lock the key cylinder.
E
SETUP
(continued)
N
Library Door
EXECUTION OF AUTO-
MATIC DRIVE DETEC-
TION MODE.
●
Execute the automatic drive detection mode of the
CD/DVD Library.
For the automatic drive detection mode, refer to the
instruction manual for the CD/DVD Library.
CAUTION
Be sure to close the drive storage cover and door of the
CD/DVD Library before turning it on.
After installing, adding, replacing or removing the drives,
be sure to execute the automatic drive detection mode.
Otherwise, a malfunction may result.
After installing, adding, removing or replacing the drives,
or changing the SCSI ID No., be sure to turn the host
computer off and then turn it on again.
Procedure for Executing the Automatic
Drive Detection Mode of the CD/DVD
Library
1.
While holding the "8" key on the control panel, turn the
power of the CD/DVD Library on.
2.
When the LCD shows "DRIVE DETECTION COMPLETED,"
turn the power of the CD/DVD Library off.
3.
Turn the CD/DVD Library on again.
The DRIVE DISPLAY of the CD/DVD Library displays
this drive as a "DVD-RAM.
Procedure for Connecting the CD/DVD
Library to the Host Computer
When using an external SCSI cable, use a SCSI-2 high-im-
pedance, shielded cable and attach the provided clamp fil-
ters.
<Clamp filter attachment method 1 >
Tighten until the tabs
are locked completely.
Werbung
