JVC KD-DB53AT Installationsanleitung Seite 3

2
Check the installation position.
<When installing on the left side>
Front pillar
Ceramic line (black part)
150 mm
70 mm
Film aerial A
Booster *2
Earth sheet *1
Cable
Recommended position
• Be sure to check the installation position of film aerial A before installing. Film aerial cannot be re-pasted.
• Keep a minimum distance of 100 mm from the other aerials.
*1 W here the earth sheet can be pasted on the metal part of the front pillar.
*2 D o not paste the booster on the ceramic line (black part) around the windscreen because there is not enough
adhesion.
The following procedures are mainly for installing on the right side:
3
Clean the windscreen with the cleaner D
provided.
Cleaner D
• Wait until the surface of the windscreen is completely
dry before proceeding.
• Warm the surface of the windscreen with the
defroster if it is cold, such as during winter.
4
Remove the Sheet I horizontally and
paste the film aerial on the windscreen.
Sheet I
• Do not touch the sticky surface.
<When installing on the right side>
Front pillar
Earth sheet *1
150 mm
Booster *2
Film aerial A
70 mm
Cable
5
Remove the Sheet II vertically and
paste the film aerial on the windscreen
slowly.
Sheet II
6
Rub the film aerial gently onto the
windscreen to allow it to stick firmly.
7
Remove the Sheet III.
Lead terminal
Sheet III
• Do not touch the lead terminal.
3
8
Align the protrusion of the booster with the ∞ mark on the film
aerial A so that the lead contact of the booster (metal part) is in
contact with the lead terminal of the film aerial.
• Do not touch the lead contact or the sticky surface of the adhesive tape on the
booster.
<When installing on the right side>
Align the protrusion with ∞ mark
Earth sheet
Film aerial A
Booster
<When installing on the left side>
Earth sheet
Booster
Film aerial A
Align the protrusion with 5 mark
9
Paste the earth sheet onto the metal part of the front pillar.
(Pasting onto the painted metal part is also acceptable.)
Front pillar
Windscreen
Booster
<Cross-section>
Earth sheet
10
Connect the cable to the DAB aerial input on the rear panel of the
unit. (➜ 2)
11
Secure the cable to the pillar at several locations using the cable
clampers C.
12
Attach the front pillar cover back to its original position.
Earth sheet
Booster
<Cross-section>
Front pillar cover
• Ensure that the front pillar cover does not damage the earth sheet and booster.
13
Check that the DAB aerial power is set to "ON".
• Initial setting: <ANT PWR ON>
Lead contact of the
booster (metal part)
Lead terminal of the
film aerial
ENGLISH