Activating/Deactivating The Alarm - Hama RC 170 Bedienungsanleitung

Note – Time zone
• The DCF signal can be received over long distances, but it always corresponds to
Central European Time, which is valid in Germany. Make sure you account for the time
difference in countries with another time zone.
• If you are in Moscow, the time is 3 hours later than in Germany. This means that you
should set +3 for the time zone. The clock then automatically sets itself 3 hours ahead
after receiving the DCF signal or according to the manually set time.
• Please see the table in order to save the appropriate time zone and time difference.
Note – Day of the week
• You can choose from English (GB), French (FR), German (DE), Spanish (ES) and Italian
(IT) for the display of the day of the week.
5.4. Home time and global time
• Press the button (5) repeatedly until the home time (C) is displayed.
• The default for this value (C – 3) is Berlin (BER).
• Press and hold the button (5) for approx. 2 seconds until the home city (C – 3) begins
to flash.
• To select the city, press the button (8) or the
pressing the button (5).
• When setting the home city, please observe the table provided above, including the display
abbreviations, time difference to UTC and availability of the DST function (summer time).
• The set home time is then automatically adopted as the normal time.
• Press the button (5) repeatedly until the global time (D) is displayed.
• This allows you to display the time for a different city/time zone.
• To select the city, press the button (8) to browse westwards or the
browse eastwards and confirm the selection by pressing the
8
button (9) and confirm the selection by
button (9) to
button (5).
5.5. Alarm
Setting the alarm time
• Press the button (5) repeatedly until the normal time (B) is displayed.
• Press and hold the button (6) for approx. 2 seconds until the hours display (E – 2)
begins to flash.
• Set the following information in the order listed:
• Hours
• Minutes
• To select the individual values, press the
your selection by pressing the button (6).
• If you do not make an entry for 30 seconds, the device automatically exits the settings
mode and the settings you made are saved.
• Press the button (6) to display the set alarm time for approx. 5 seconds.

Activating/deactivating the alarm

• Move the alarm slide switch (7) upwards. A red surface will be visible underneath the
slide switch.
The alarm is activated and the alarm clock icon (E – 3) is shown on the display (4).
• Move the alarm slide switch (7) downwards. The surface underneath the slide switch is
black.
The alarm is deactivated and the alarm clock icon (E – 3) disappears from the display (4).
Stopping the alarm/snooze function
• If the alarm is activated, it is triggered at the set time and an alarm signal sounds for one
minute. The alarm automatically stops after this time and is then triggered again the next
day at the set alarm time.
• To stop the alarm early, move the alarm slide switch (7) downwards until the surface
underneath the slide switch is black. The alarm is now deactivated.
Move the alarm slide switch (7) upwards again to activate the alarm for the next day.
Note – Snooze function
• While the alarm signal is sounding, press the SNOOZE/LIGHT button (1) to activate
the snooze function. The alarm clock icon (E – 3) on the display (4) begins to flash. The
alarm signal will be stopped for 5 minutes, after which it will sound again.
• The snooze function can be activated four consecutive times.
button (8) or the button (9) and confirm
9