Herunterladen Inhalt Inhalt Diese Seite drucken

Operation Safety Zone; Adjusting Height Of Brush; Adjusting Brush Angle; Adjusting Handlebars Height - Texas A/S Smart Sweep 800 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für Smart Sweep 800:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Clutch handle 2
activating brushes:
To operate the black handle 2 in Fig. 8, pull the handle
down and the brushes will activate.
Grip for brush speed 3
Push the handle forward and increase the rpm of the
brushes. When the handle is pulled back, the rpm is
reduced. Press down the locking button on the handle
to be able to pull the handle back.
Throttle grip 4
setting engine rpm:
To activate the throttle handle, push the handle
forward.

Operation safety zone.

The operator may not leave the operation area marked
in Figure 10 when operating the machine. During
operation, should the operator needs to leave the
safety zone, for example to adjust the brush height or
secure an accessory, he or she must first stop the
engine.

Adjusting height of brush

Regulating brush speed:
When the brushes start to wear, it is necessary to
adjust how close the brushes are to the ground. To
adjust the height of the brush, adjust up or down the
rotary handle above the brush, until the desired
position is achieved. See Figure 9.
1. Loosen the contra nut (1).
2. Screw the adjusting handle (2) up or down to
the desired position.
3. Tighten the contra nut (1) to secure the
adjustment handle in position.

Adjusting brush angle

The brush can be turned 25 degrees to each side. Do
this by pushing the brush angle support rod on the
sweeper down, turning the brush and releasing the
handle, so that the pawl clicks into place.

Adjusting handlebars height

Adjust the handlebars, so that the working height is
optimal. Adjust the handle on the underside of the
handlebars. Figure 2, D

Selection of gear

Smart Sweep 800 is equipped with three forward gears
and one reverse gear.
Selecting a gear:
Release the sweeper clutch handle, Fig 8-1, so that
the clutch handle is not activated.
The gear can now be chosen.
NOTE: Never change gear when the clutch handle
is activated (fig. 8-1). This will seriously damage
the gearbox!
15

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis