Contents; Identification Of Parts; Fitting; Assembling The Machine - Texas A/S Smart Sweep 800 Bedienungsanleitung

Contents

Figure 1:
A. Basic
B. Handle bars
C. Brush angle support rod
D. Assembly set for steering
E. Brush
F. Manual
G. Gear selector

Identification of parts

Figure 2:
A. Control of brush rpm
B. Clutch handle – to activate operation
C. Handle bars
D. Adjustment of oversteering
E. Brush angle support rod
F. Engine
G. Gear selector
H. Wheel
I. Support wheel for brush
J. Clutch handle – to activate brushes
K. Throttle
L. Underside.
M. Adjustment of sweeping height
N. V-belt guard
O. Fitting for snow scraper blade/collection box
P. Brush

Fitting

The actual model can vary from the illustrations
shown.
Check the tyre pressure on both wheels before use.
The correct tyre pressure is 30 psi/2 bar. Figure 7.
Operating the machine with tyre pressure
that is too low can destroy the tyres and

Assembling the machine

The sweeper is supplied from the factory almost ready
for operation. Only a few parts need to be fitted.
1. Figure 3. Set the oversteering (1) down over
the fixed bolts (3) on the machine. Next, screw
the nuts (2) securely.
2. Figure 4. Fit the support legs, using the
accompanying nut, spring and washer. See
Figure 4.
Set the washer (5) down over the threaded pin
(2) and then the spring (4). Press the brush
angle support rod (1) down over the threaded
pin and screw on the nut (3) securely.
3. Figure 5. Fit the gear selector using the
accompanying bolt and nut.
Fit the gear selector (1) using the bolt (3) and
nut (2).
When fitting the gear selector when the
machine is new, bolt hole no. 1 on the gear
fitting must be selected. When the machine
hose!
has operated for 100 hours or you feel that the
speed is waning, change to bolt hole no. 2.
4. Figure 6. Fit the brushes on the brush shaft
(1). When the brush is pushed in over the shaft
(2), fit the outer metal cups (4) and secure all
of it with the accompanying nuts (5).

Operation

Before use, the following engine
instructions for readying the engine must
be followed.
Before use, remove all foreign bodies from the area.
Stone, glass, branches and similar can damage the
sweeper. At the same time, check that the bolts on the
sweeper are secure.
Check the oil level in the engine before
starting. See the attached guide.
Starting the engine:
1. Open the fuel cock.
2. If the engine is cold, open the choke.
NB: If the engine is warm, the choke is not
necessary.
3. Open for full power, i.e. set the throttle handle
" "
to start .
4. Carefully pull the recoil start until you feel
resistance. Next, pull strongly on the recoil to
start the engine. Carefully let the recoil start
cord move back to the start position.
5. Regulate the choke until the engine runs
evenly.
Stopping the engine:
1. Set the throttle handle to minimum/stop.
2. Close the fuel cock.
Choke
STOP
–
Clutch Handle 1
To operate the black handle 1 in Fig. 8, pull the handle
down and the sweeper will move forwards or
backwards. To change direction, release the grip and
put the gear selector into the desired direction and
activate the handle again.
14
Forward and Back: