Damaged Blades; Change The Blade; Sharpen Knives - Zipper ZI-BRM40 Bedienungsanleitung

17.3

Damaged blades

Note: Wear thick gloves for mounting and sharpening the cutting blade. Check that the blade
is always well balanced.
If the blade is pushed, despite all precautions for foreign objects / obstacles, first turn off the
engine and disconnect the spark plug. If the blade stops, tilt the mower and the blade
checked for possible damage.
Deformed or bent blades must not be re-aligned.
Damaged parts must be replaced immediately. After hitting an obstacle, the mower must be
checked by an authorized service workshop. Sure before use that knife and knife holder are
not damaged. If necessary, replace such parts or checked. Never work with an unbalanced
blade - this cause vibration and further damage may result.
17.4

Change the blade

When changing the blade are to protect your
the spark plug is to be
Use to help a holding pen as a blocking device for the knife. The blade mounting screw has a
normal right hand
When reassembling the slip clutch on the exact order in which these components were
previously installed
The screw diameter must be attached to the specified torque of 45 Nm
Make sure that the cutting edges pointing in the direction in which the motor also rotates.
When replacing, use only cutter that match the original enclosed blade in quality
and size.
17.5

Sharpen knives

Note: To clean work with, you should raise it at regular intervals. (after about 25 hours)
The cutting blade can be sharpened with a metal file.
Even better is a sharpening / grinding in the customer service workshop. There is also paid
particular attention to the fact that is sanded off on each side the same amount, to avoid any
imbalance.
The sharpening of the cutting edge may only be up to the impressed mark.
Use only original spare
and may also adversely affect your safety. Please contact your vendor for all required spare
parts.
Z.I.P.P.E.R Maschinen Austria
Benzinrasenmäher / Gasoline lawn mower ZI-BRM35 / ZI-BRM40 / ZI-BRM60
deducted.
thread. To loosen this screw is best to use a 17 mm socket
(Fig. 13).
parts. Parts of inferior quality can cause serious damage to the unit
www.Zipper-maschinen.at
hands, wear appropriate
MAINTENANCE
gloves. Before
wrench.
Seite 37