Troubleshooting - Zipper ZI-BRM40 Bedienungsanleitung

18

TROUBLESHOOTING

Trouble
Engine will not start
Rough running,
vibrations
Engine runs irregu-
lar
Low quality cut
Mower does not col-
lect properly
Z.I.P.P.E.R Maschinen Austria
Benzinrasenmäher / Gasoline lawn mower ZI-BRM35 / ZI-BRM40 / ZI-BRM60
Possible cause
Engine brake lever pressed correctly?
Engine Reg. Lever inposition ?
cable for engine brake adjusted ?
plug or plug cap defect
fuel tank empty
Loose engine screws
Loose blade screw
damaged or unbalanced blade
friction clutch worn
air filter dirty
bent / damaged throttle cable
spark plug dirty
blade is blunt
cutting height too low
engine rpm too low
too low engine rpm
cutting height set too low with high
grass
blade worn
catcher fabric clogged
www.Zipper-maschinen.at
TROUBLESHOOTING
Solution
press/pull brake lever correctly
select correct position
check adjustment
adjusted ?
clean or replace plug or cap
refuel
tighten screws
check blade tightening
balance or replace blade
replace friction washers
clean air filter or replace
adjust / replace cable
clean plug
sharpen blade
adjust cutting height
set Eng. Reg. Lever to max.
set Eng. Reg. Lever to max.
adjust cutting height
replace blade
clean catcher or replace
Seite 38