Hilti TE 80-ATC Bedienungsanleitung Seite 29

4. Push the insert tool into the chuck and rotate it
while applying slight pressure until it engages in
the guide grooves.
5. Push the insert tool further into the chuck until it
is heard to engage.
6. Check that the insert tool has engaged correctly
by pulling it.
en
7.1.2 Removing the insert tool 4
1. Disconnect the supply cord plug from the power
outlet.
2. Open the chuck by pulling back the insert tool
locking sleeve.
3. Pull the insert tool out of the chuck.
7.2 Operation
CAUTION
Working on the material may cause it to splinter.
Wear eye protection and protective gloves. Wear
breathing protection if no dust removal system is
used. Splintering material presents a risk of injury to
the eyes and body.
CAUTION
The work generates noise. Wear ear protectors.
Exposure to noise can cause hearing loss.
CAUTION
Switch the power tool on only after bringing it into
the working position.
CAUTION
Do not operate the function selector switch while
the motor is running.
7.2.1 TPS theft protection system (optional)
NOTE
The power tool may be equipped with the optional
theft protection system. If the power tool is equipped
with this feature, it can be unlocked and made ready
for operation only through use of the corresponding
TPS key.
26
Printed: 13.09.2012 | Doc-Nr: PUB / 5071146 / 000 / 00
7.2.1.1 Unlocking the power tool 5
1. Plug the supply cord into the power outlet. The
yellow theft protection indicator LED blinks. The
power tool is now ready to receive the signal
from the TPS key.
2. Hold the TPS key against the lock symbol. The
power tool is unlocked as soon as the yellow
theft protection indicator LED no longer lights.
NOTE If, for example, the electric supply is
briefly interrupted due to a power failure or dis-
connected when moving to a different workplace,
the power tool remains ready for operation for
approx. 20 minutes. In the event of a longer
interruption, the TPS key must be used again to
unlock the power tool.
7.2.1.2 Activation of the theft protection system
for the power tool
NOTE
Further detailed information on activation and use
of the theft protection system can be found in the
operating instructions for the theft protection system.
7.2.2 Hammer drilling 6
NOTE
Working at low temperatures: The hammering mech-
anism works only when the power tool has reached
a minimum operating temperature. Bring the tip of
the drill bit or chisel into contact with the workpiece
and allow the power tool to run under no load until
it reaches the minimum operating temperature. If ne-
cessary, repeat this procedure until the hammering
mechanism begins to operate.
1. Turn the function selector switch until it engages
in the "Hammer drilling" position.
2. Bring the side handle into the desired position
and check that it is fitted correctly and secured.
3. Plug the supply cord into the power outlet.