On/Off - auna MD-210 BT Bedienungsanleitung

Press POWER to turn the device on or off.

On/off

Press MODE to select from the different modes.
Mode selection
Press SEL repeatedly until the display shows LOUD ON or LOUD OFF. Turn the volu-
Loudness
me knob to select out of these options (press SEL to confirm).
Press MUTE to mute or unmute the audio output.
Mute
Turn the volume knob clockwise to increase, anti-clockwise to decrease the volume.
Volume
Press SEL repeatedly until the display shows BAS. Turn the volume knob to adjust
Bass
the bass. (Inactive when in DSP mode)
Press SEL repeatedly until the display shows TRE. Turn the volume knob to adjust the
Treble
treble. (Inactive when in DSP mode)
Press SEL repeatedly until the display shows BAL. Turn the volume knob to adjust
Balance
the stereo balance.
Press SEL repeatedly until the display shows FAD. Turn the volume knob to adjust
Fader
the fader.
Press SEL repeatedly until the display shows EQ. Turn the volume knob to select
DSP EQ mode
from FLAT, ROCK, POP or CLASS. In FLAT mode, DSP is set inactive.
Press SEL repeatedly until the display shows BEEP. Turn the volume knob to adjust
Beep
the keys „beeps" or deactivate completely.
Press and hold SEL for 2 seconds untin TA ALARM is displayed. Then, press SEL
repeatedly until P_VOL is displayed. Adjust by turning the volume knob (standard
Standard Volume
output volume when turning the device on).
Press and hold CLK to display the time. Keep holding, until the time display starts
flashing.
By turning the vol knob you can now change the hour. Press SEL to process to chan-
Clock
ging the minutes. After successfully changing the displayed time, press CLK to save
and confirm.
Press BND repeatedly to select from band FM1, FM2, FM3, AM1, AM2.
Band Select
Press Back/Next to manually scroll through the frequencies by steps of 0.05Mhz.
Manual Station
Press and hold for automatically scaning to the next available/receptable station.
Scan
16
Operation
Basics
FM Radio