Fire Hazard - Silvercrest SPCM 1200 A1 Bedienungsanleitung

• Make sure that the power cord does not
become wet during operation.
• Unplug the appliance immediately after use.
The appliance is completely disconnected,
only when you pull out the power plug from
the power socket.
• Do not open or repair the appliance casing
yourself. In this case, the device is not safe
and the warranty is voided.

Fire hazard!

• Do not use the appliance near hot surfaces.
• Some parts of the appliance become very hot
during operation. Therefore, do not touch its
surface to avoid burn injuries.
• Do not keep the appliance in places that are
exposed to direct sunlight, as this could lead to
overheating and cause irreparable damage.
• Do not leave the appliance unattended when
in use.
• Do not operate the appliance for more than
6 minutes at a time.
• After every two consecutive quantities of
popcorn, allow a pause of at least 10 minutes
by switching the appliance off before using it
again.
• Do not put ingredients like sugar, oil, butter,
salt, margarine etc. into the popping chamber;
as such substances can cause damage to the
appliance.
• Never operate the appliance without maize
corn in the popcorn chamber.
Injury hazard!
• Keep children away from the connecting
cable and the appliance. Children frequently
underestimate the danger from electrical
appliances.
• Make sure to find a safe place for the
appliance.
• Do not operate the appliance, if it has fallen
off or is damaged. Get the appliance checked
and if necessary, repaired by experts.
Operation
Making popcorn
1. Switch the appliance off and remove the
cover , before filling the popping chamber
1
with maize kernels.
7
Ensure that you only use dry popcorn maize.
2. Fill the popping chamber
mately 120 g (4 measuring cups
maize kernels.
Caution:
Never fill less than approximately 30 g (1 measu-
ring cup ) into the popping chamber
2
put ingredients like sugar, oil, butter, salt, margarine
etc. into the popcorn chamber
ces may damage the appliance.
3. Place the cover
asuring cup
2
4. Place a heat-resistant serving bowl below or at
the dispensing chute
when done.
5. Plug in the power cord to mains and use
the ON/OFF switch
appliance. Now the indication lamp
lights up.
6. Switch the appliance off using the ON/OFF
switch once the popcorn is ready. Now the
4
indication lamp
7. Remove all residues from the popping chamber
, before starting with another quantity of -
7
popcorn.
- 3 -
with approxi-
7
) of
2
. Do not
7
, as such substan-
7
along with the mounted me-
1
on the casing .
3
, to collect the popcorn
6
to power up the
4
5
is turned off.
5