Setting The Flash Time; Setting The Ring Volume; Caller-Id Function (Clip); New Calls - Topcom butler 2700 Bedienungsanleitung

B2700_euro.QXD
Butler 2700/DUO

5.10.1 Setting the Flash time

Set the switch on the bottom of the base in the desired posi-
tion!

5.11 Setting the ring volume

Press the volume button
desired handset ring volume is heard.
Remark: The Base ring volume cannot be set!

6. CALLER-ID FUNCTION (CLIP)

The Butler 2700 displays the telephone numbers of incoming
calls. This function is only possible if you are subscribed to a
telephone operator that provides this service. Contact your
telephone provider for more information. When you receive a
call, the numbers are saved in a Call list. This list can hold
10 telephone numbers (each of max. 10 digits). If the num-
ber is longer then 10 digits, only the last 10 digits are shown
and stored!

6.1 New calls

When you've received a new unanswered call, the CLIP sym-
bol appears on the display.

6.2 Consulting the Call list

When you consult the Call list, you will notice that the list
always starts with the last call received.
• Press the Call Log button
button.
• Use the Up
list. The Up key
record, the Down key
record.
• You can leave the Call list by pressing the R button.
24/6/02 9:09 am
and Down
will skip backwards to the previous
will skip forward to the next
12
Pagina 12
a few times in standby until the
or the Up or Down
buttons to scroll through the