Technical Data: Mf-Serie - EMAG EMMI-12HC Bedienungsanleitung

End of the cleaning process
After ending of the cleaning process press ON/OFF to turn off the device. Hold down the key for 1
second. Remove the cleaned items in the stainless steel basket from the tube and rinse them with
clean water to solve any retarded dirt. The cleaning process can also be shortened by pressing
the «START / STOP» button slightly. The cleaning tub does not have to be emptied after each
cleaning process, unless the cleaning liquid is extremely soiled.
However, it is recommended that the device have to be emptied whenever it is not used for an
extended period of time. There are certain residues of soiling which can lead to corrosion in the
stainless steel tank. Do not use aqueous cleaning additives in the acidic range (e.g. fluoride, chlo-
ride or bromide ions). Explosive substances and flammable cleaning solutions cannot be used in
the stainless steel tub and should be sonicated.
After the connection cable has been pulled out of the device and the socket, the liquid can be
emptied over the tank corners or via the drain tab. It is recommended to dry the tub with a cloth.
Note: Please ensure that a degassing time is imperative by hard water (high degree of lime). In this
case we recommend degassing the water for at least 2-3 min. before placing the parts in to
the device.

9. Technical Data: MF-Serie

MF-Serie
External dimensions L x W x H (mm)
Internal dimensions L x W x H (mm)
Content (liter)
Ultrasound power (watt)
Heating power (watt)
Generator (Watt)
Outlet valve
Frequency (kHz)
Power (Watt)
Technical changes reserved.
Emmi®-MF30
265 x 165 x 225
240 x 140 x 100
2,7
160
120
2 x 80
Yes
20/40
280
Emmi®-MF60
330 x 175 x 290
300 x 150 x 150
6,0
240
120
3 x 80
Yes
20/40
360
21