Technical Data; Important Notes - EMAG Emmi-04D Bedienungsanleitung

Volume (l)
Dimensions Tank (mm)
Power Supply
Protection Class
Max. Power (W )
Timer (Min.)

Important Notes

• The equipment must ONLY be operated with the supply voltage indicated on the type label on the
bottom of the equipment.
• The equipment is not suitable for permanent operation.
• The ultrasonic equipment must only be operated with sufficient water filling (approx. ¾ of the tank
volume shall be filled with water which is approx. 1 cm under upper tank rim).
• It is normal that the upper rims of the tank warm up during operation
Operating Instruction
Fill tank with water and connect power connector with main source. For efficient cleaning of your goods
we recommend to use certain of our cleaning adders (please refer to below listing of cleaning adders).
For the cleaning of looking glasses and prosthesis please use the inlet basket (2).
By pushing the ON switch (1) the cleaning operation can be started. The duration of cleaning depends
on the kind of dirt on the goods to be cleaned. When operating a blue LED lights up and indicates the
operation of the equipment. After approx. 7 minutes the equipment stops automatically. If you wish to
stop the equipment earlier please push the OFF switch.
After termination of the cleaning remove cleaned goods from the tank and shortly wash them up under
running water in order to remove dirt particles, which may still stick to the goods.
After termination of the one or more cleaning cycles it is recommended to empty the tank, to wash up
the tank and to dry it with a cloth. Please make sure that no water can penetrate into the equipment
through the slots in the bottom of the equipment.
Important:
Please, note that when the tank is filled with fresh water - depending on the degree of hardness of the
water - a certain operating time for the out gazing of the water shall be considered. The best efficiency is
achieved when using out gazed or distilled water.
If no distilled water is available, please operate the equipment filled with water for approx. 5 to 10 minu-
tes before putting goods in for cleaning.
10

2. TECHNICAL DATA

Emmi 04D
0,6
160x90x50
230V~/ 50 Hz
IP 20
max. 50
90-180-280-380-480 sek.
Onlineshop: ultraschall-welt.de
Emmi 05P Emmi D21
0,5 2,0
175x80x40 185x150x80
230V~/ 50 Hz 230V~/ 50Hz
IP 20 IP 20
max. 50 max. 80
1 - 9 5-10-15
Technical changes reserved!