Test Button And Display - Gear 13811..021 CGLine Betriebsanleitung

If the time cannot be set to occur during idle operating times in this way, the automatic duration test
can be deactivated with GuideLed CGLine luminaires. To implement this, switch the DIP switch 3
to ‚Off'. The duration test can then be started manually at a suitable time with the test button (press
and hold for 5 – 10 s).
If this test is not started within 12 months, a yellow LED on the luminaire lights up to signal a due
test.
When the LED at the test button blinks alternately green/red after a DT this test failed. The battery
has to be exchanged (Order no. 400 71 353 6.6.7). Please note the date of the first commissioning to
the new battery.
6.3 Dim-Level
Setting the brightness in mains mode by using the test button:
- Push the test-button for t < 1 s
- After the first flash of the LED the brightness can be changed by pushing the button again in 3
steps (100% / 30% / 10%). Every push of the button raises the brightness for 1 step. If the hightest
step is reached it begins again with the lowest.

6.4 TEST button and display

The following can be started and displayed with the test-button:
Display and user functionality of the foil key pad
a. Status display
Status
No failure
Emergency
Delay on mains return
Function test
Duration test
Luminaire is blocked
Charging failure
Functions test failed
Durations test failes
Lamp failure
1-h Emergency operation
3-h Emergency operation
8-h Emergency operation
Display of luminaire
address
Duration test not possible
because battery partly charged
Reset of luminaire
No duration test during the last
12 months
Legend:
LED lights up
LED does not light up
Operating Instructions
GuideLed self contained luminaire
SL 13811 ... 13822 CGLine
LED
lights up green
LED is off
/
blinks green, yellow
in rotation
blinks green
flashes green
blinks yellow
flashes red
/
blinks green, red in rotation
/
blinks green, red in rotation
/
blinks yellow, red in
rotation
red
yellow
green
[100] green
yellow
[10]
[1] red
red for 1s
(1s)
after button was pushed
/
500ms green,500ms red
yellow
LED blinks
LED flashes
Important displays with the test-button:
TEST
After
pushing the
test button
for:
(t < 1s)
Colour orange: a mixed colour
from green and red
CEAG Notlichtsysteme GmbH
Also, if ambient tempera-
ture too low, see specifi-
cation 5.
Exchange battery -
order no. 400 71 353 667.
See also chapter 8.
16.