Scanning Failure; Repeated Scanning Failure - Philips dtr 300 tnt Benutzerhandbuch

DTR 300 sans esp_140205.qxd
16 FIRST INSTALLATION
14/02/05 16:16 Page 16
5.2

Scanning failure

No channels could be found. A scan failure message is
displayed.
Before starting a new scan
It is recommended to perform the following checks:
- connections to your receiver (see chapter 4),
- signal quality (see paragraph 7.3.3),
- antenna installation,
- channel(s) available in the region corresponding to your
area (1).
The scan failure message is displayed.
- Press <OK> to exit this screen and access the main menu.
- Proceed with installation as described in paragraph 7.3.2.
Note: if the same failure message appears after a while, refer to
chapter 10.
(1) To check whether you can receive digital television in
your region:
for Finland,
for France, consult web site www.tdf.fr
for Germany,
for Italy,
5.3

Repeated scanning failure

No channels could be found, even after checking the signal
quality delivered by your aerial.
Either your aerial is not pointing properly at the digital TV
transmitter, or your aerial installation needs to be upgraded,
or you are not in the coverage area to correctly receive
digital television. Please refer to the Troubleshooting guide at
the end of this user manual.
For a proper diagnosis, call your electrical retailer.