Station Memory - Peaq PBR210 Bedienungsanleitung

ENGLISH
Radio
PLAYBACK
Select radio source by pressing RADIO
button on remote control.
Setting frequency automatically:
Press and hold the TUNE - /
+ / for 2 seconds. Scanning starts in the
desired direction until a station with sufficient
signal is found.
Setting frequency manually:
Each time pressing TUNE - /
will decrease or increase the frequency by
an increment.
RDS
If a station transmits an RDS signal, the name
of the station is displayed shortly instead of
the frequency. With the button RDS you can
access additional information, if available.

STATION MEMORY

The appliance can save up to 40 stations.
Saving stations automatically:
Press AUTO SCAN. The radio will search for
stations with sufficient signal and save them
automatically. Previously saved stations are
deleted in the process.
If more than 40 stations have been found,
FULL will be displayed and scanning
terminates.
Saving stations manually:
Set the desired station as described above.
Press PRO sensor button or PROGRAM on
the remote control. A memory slot number
will be flashing in the display. Directly enter
the desired memory slot number with
number buttons. Press PRO or PROGRAM
again to save.
Selecting stations from memory:
Press PRESET + /
repeatedly to access stations in the
memory.
MONO/STEREO
or TUNE
Stations with a weak signal may cause
faults in stereo mode. In such case, press
STEREO/MONO AUDIO to switch to mono
mode.
or TUNE + /
46
or PRESET - /