Internal Switches For High-Pass Filters; Remote Control Ports For Attenuation; Remote Control Ports Connection; Operation And Usage - Ecler HZA4-120F Bedienungsanleitung

3.5. Internal switches for high-pass filters

Inside the amp there are four jumpers to activate/deactivate the high-pass filter for each amplifier
channel, with a cutoff frequency set at 70Hz and a slope of 18dB/octave. The high-pass filter is
recommanded for some 100V line applications, especially when audio content is primarily vocal (public
address announcements, for example).
See the SETUP DIAGRAM for more information.

3.6. Remote control ports for attenuation

The HZA4-120F features 4 remote control ports labeled "REMOTE CONTROL" (35, 36, 37, 38)
on its rear panel. You can connect WPm series, REVO control panels etc. to each of these ports to
remotely attenuate the input signal (and therefore, the output volume of affected channels).
The maximum level of each amplification channel (and therefore its output volume) that can be
reached by the remote attenuator is determined by the position of its front knob (21, 22, 23, 24).

3.7. REMOTE CONTROL ports connection

The signal remote attenuation level for each input channel can be set by using 3 types of external
devices connected to the rear panel REMOTE CONTROL ports:
a) Using a remote potentiometer with nominal resistance between 10k and 50k, WPm series or
equivalent.
b) Using a device that generates a control voltage from 0 to 10V DC.
c) Using remote relays/dry contacts.
NOTE: you can connect up to 16 REMOTE CONTROL ports in parallel to the same hardware
control potentiometer. You have to merge the ground of all amplifiers belonging to these ports.
The connection cables can be up to 500m long if a section of 0.5mm
Consult the available accessories at your ECLER dealer or at www.ecler.com.

4. OPERATION AND USAGE

4.1. Start up

This will be done through the POWER ON (25) switch and the built-in indicator immediately lights.
In a complete audio installation, it is important to start up the equipment in the following
sequence: sound sources, mixer, equalizers, active filters, processors and finally power amplifiers. To
turn them off the sequence should follow an inverse pattern.
2
is used.
7