Safety Instructions - Renkforce E-SA 9 Bedienungsanleitung

Safety instructions

Dear customer, The safety instructions and danger warnings below are not only for the protection of the
device but also to protect your well being. Please read carefully through the following points:
Downloaded from www.Manualslib.com
In the case of damages which are caused due to failure to observe these operating instructions,
the guarantee will expire. We do not assume any liability for any damage arising as a
consequence!
Nor do we assume liability for damage to property or personal injury, caused by improper use
or failure to observe the safety instructions. Any claim to warranty will lapse in such cases!
• For safety and licensing (CE) reasons, unauthorised conversion and/or modifications to the product
are not permitted.
• All persons operating, installing, setting up, commissioning or servicing this device must be trained
and qualified correspondingly and observe these operating instructions.
• The device is designed according to protection class II. Only connect the amplifier to a normal mains
socket (230 V~/ 50 Hz).
• The device must be set up correctly. Please also follow these operating instructions.
• When setting up the product, make sure that the mains cable is not pinched or damaged by sharp
edges.
• If the amplifier or its connection cable is damaged, do not touch it. First of all, de-energize the
corresponding mains socket (e.g. via the respective circuit-breaker) and afterwards carefully pull the
mains plug from the socket. Do not use the product afterwards, but take it to a specialist workshop.
• The product is not a toy and should be kept out of reach of children! Children cannot judge the
dangers involved, when dealing with electrical devices.
• Do not place any containers with liquid, e.g. buckets, vases or plants in the immediate proximity of
the product. Liquid could get inside the housing and impair electrical safety. There is furthermore a
high risk of fire or of a life-threatening electric shock. If this is the case, de-energize the respective
socket (e.g. switch off circuit breaker) and only then pull the plug-in mains unit from the socket.
Disconnect all cables from the device. Afterwards, the product must no longer be used, bring it to
a specialist workshop.
• Never touch the mains plug of the amplifier with wet or damp hands. There is a risk of a fatal electric
shock.
• Make sure the device is adequately ventilated when in operation. Do not cover the ventilation
openings with magazines, blankets, curtains or similar. Keep a minimum distance of approx. 15 cm
to other devices.
manuals search engine
23