Repeat Function; Programming The Cd Player - JGC RRMP-6770 Bedienungsanleitung

CD PLAYER

Repeat function

• At any time during playback, press the CD
• Press the CD
• Press the CD

Programming the CD player

• The CD player can be programmed to play any sequence of up to 20 tracks, as desired. Always
press the CD STOP key before starting the programming.
• Press the CD
the CD player is now in memory programming mode. At the first memory position, press the CD
BACK or CD NEXT key to select the track you wish to be stored in the first memory position, and
press the program key to confirm your selection.
• When you press the CD
(e.g. 02).
• Repeat the previous two steps each time selecting any track number of your choice to be stored in
the successful memory positions.
• After each track number remember to press the CD
• After a maximum of 20 songs (or less) have been selected as described above, press the CD
PROGRAM key.
• The display will now show the exact track sequence in memory by displaying all the track numbers
rapidly. Also, the PROG symbol will be shown to indicate that you have saved a program memory
sequence.
• Press the CD
• To clear the entire program which is stored in the memory, simply press the CD
or put the function switch to OFF.
22
RRMP-6770.indd 22
REPEAT key once to repeat the current track.
REPEAT key twice to repeat all tracks on the CD.
PROGRAM key. The display will show PROG and the 01 will flash to indicate that
PROGRAM key the display will advance to the next memory position
PLAY/PAUSE key to play back the saved sequence in the program memory.
REPEAT key as follows.
PROGRAM key.
STOP key twice
5/8/09 10:21:32 AM