Audiosonic CD-1576 Bedienungsanleitung Seite 4

General Operation
General operation
Select the source by setting the FUNCTION SELECTOR to CD, OFF or RADIO.
Set the desired volume level using the VOLUME KNOB.
To turn off the unit, set the FUNCTION SELECTOR to OFF.
Radio
To listen to the FM radio, extend the telescopic antenna and adjust it for optimum reception. Reduce the
length of the antenna if the signal is too strong (if you are very near the transmitter, for example).
As the unit is equipped with a built-in antenna, the telescopic antenna is not needed to listen to AM stations.
Move the entire unit to adjust the built-in antenna for optimum reception.
Radio reception
Set the FUNCTION SELECTOR on RADIO.
Position the BAND SELECTOR on the desired band: AM, FM or FM ST.
Turn the TUNING KNOB to search for the desired station.
NOTE:
The FM stereo indicator comes on if the BAND SELECTOR is set on FM ST. and you have tuned the radio to
an FM stereo station.
When you have finished listening to the radio, position the FUNCTION SELECTOR to OFF.
Stereo headphones jack
Connect headphones with the volume set low and increase it if required. Prolonged listening through some
headphones at high volume settings can result in hearing damage.
Reduce the VOLUME to a low level before putting on the headphones. You can then adjust the VOLUME
progressively to a comfortable level.
UK-6
CD
The CD player supports audio discs, CD-R, CD-RW. Do not attempt to read CD-ROM, CDi, VCD's, DVDs or
DATA CDs.
Note:
Even if this portable radio-CD player is able to read CD-R and CD-RW discs, it is not possible to offer a
100% guarantee that all CD-R / RW discs can be read; playback depends on the quality and condition of
the blank discs that you use, among other things. A playback failure does not necessarily indicate that the
unit is malfunctioning.
Position the FUNCTION SELECTOR on CD .
To open the CD door, raise it by pressing the corner marked OPEN / CLOSE.
Insert a CD, CD-R, CD-RW , printed surface facing upwards and gently close the CD player door.
Start playback by pressing PLAY / PAUSE.
Press PLAY / PAUSE to PAUSE and PLAY. To stop CD playback, press STOP.
NOTE:
CD playback stops automatically when the CD compartment is opened, the radio function is selected or the
CD has finished.
Selecting a different track
During playback, press NEXT or BACK on the unit to select a track.
If you have selected a track number in Stop or Pause mode, press PLAY / PAUSE to resume playback.
Briefly press NEXT to pass to the next track or press NEXT several times until the desired track number
appears in the display.
Briefly press BACK to return to the start of the current track.
Press BACK several times to find a previous track.
Searching for a passage on a track
Press and hold BACK or NEXT to read the track in fast forward mode with the volume muted.
Release the BACK or NEXT button periodically until you have found the desired passage (normal playback
resumes automatically).
Repeat (CD only)
Whilst in play mode, press the REP button once to playback the current track repeatedly.
Whilst in play mode, press the REP button twice to playback the entire CD repeatedly.
Programming of track numbers
Up to 20 tracks can be programmed in any order. If desired, a given track can be programmed more than
once.
In STOP mode, press BACK or NEXT to select a track.
When the desired track number appears, press the PROG button once to record the track (the unit displays
"prog", briefly followed by the track number selected).
Repeat steps 1 and 2 to select and program the desired tracks.
To start playback of your programmed tracks, press PLAY / PAUSE.
The display will show "FUL" if you attempt to program more than 20 tracks.
Program check
In STOP mode, press the PROG button. (the unit displays the track numbers in the order they are
programmed).
Deleting a program
Perform any of the following operations to delete the memory:
• Open the CD door;
• Select the RADIO source;
• Press STOP twice.
UK-7