Set-Up - Renkforce DB-820 Bedienungsanleitung

Set-Up

Do not drill or screw additional screws into the casing in order to fasten the
device; this would damage the device.
When setting up the device, make sure that it has a stable footing and place
it on a stable underground, since falling off of the DAB radio may injure
persons.
When setting up the device, make sure that the connection cables are
neither pinched nor damaged by sharp edges.
Always place cables so that no one can trip over them or be caught in them.
Danger of injury!

Due to the diversity of furniture paints and polishes used, it is possible that the
device's feet will leave visible residue on furniture. The device therefore should
not be placed on valuable furniture surfaces without any suitable protection.
• Place the device on a level and dry surface.
• Unroll the aerial (6) completely.

The radio reception strongly depends on the aerial alignment. If reception is
impaired in operation, try aligning the aerial differently.
• When selecting a place of set-up, make sure it is not exposed to direct solar radiation,
vibrations, heat, cold and moisture.
• There also must not be any strong transformers or motors in the area of the DAB radio, since
they may influence the device and its reception.
30
