Herunterladen Inhalt Inhalt Diese Seite drucken

Blaupunkt KC BT 25 Bedienungsanleitung Seite 24

Inhaltsverzeichnis

Werbung

KC BT 25
2)
The batteries should be drawn to the environmental aspects of battery disposal.
3)
Battery usage CAUTION-to prevent battery leakage which may result in body injuries,
property damage, or damage to the apparatus:
a.
b.
c.
ERP2 - (Energy Related Products) note
This product with ecodesign complies with the stage 2 requirements of Commission Regulation (EC)
NO. 1275/2008 implementing Directive 2009/125/EC regard to standby and off mode electric power
consumption of electronic household and office equipment. After 30 minutes without any audio
input, the device will automatically switch into standby mode. Follow up the instruction manual to
resume the operation.
Important note:
This device is equipped with an energy saving mode: if no signal is given during 30 minutes the
device will switch automatically into standby mode in order to save energy (ERP 2 standard). Please
note that low volume setting in the audio source may be recognized as "no audio signal": this will
affect the capability of signal detection from the device and can also originate an automatic switch
into standby mode. If this happens please reactivate the audio signal transmission or increase the
volume setting on the audio source player (MP3 player, etc.), in order to resume playback. Please
contact the local service center if the problem remains.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any
use of such marks by us is under license. Other trademarks and trade names are those of their
respective owners.
Warning
This appliance is not intended for use by persons (including children) with reduced physical sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible for their safety. Children
should be supervised to ensure that they do not play with the appliance.
1.
To prevent possible hearing damage, do not listen at high volume levels for long time periods
respectively a sudden high volume level.
2.
Never use the device unsupervised! Switch off the device whenever you are not using it, even if
this only for a short while.
3.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
4.
Before operating this system, check the voltage of this system to see if it is identical to the
voltage of your local power supply.
5.
The unit should not be impeded by covering the ventilation opening with items such as
newspaper, table-cloths, curtains etc.
6.
Make sure that there are at least 20 cm of space above and at least 5 cm of space on each side of
the unit.
Install all batteries correctly, + and – as marked on the apparatus.
Do not mix batteries (old and new or carbon and alkaline, etc.)
Remove batteries when the unit is not used for a long time.
21

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis