What To Do If - Electrolux IK1875Z Benutzerinformation

10 electrolux
the food inside from spoiling in case of a
power failure.

WHAT TO DO IF...

Warning! Before troubleshooting,
disconnect the mains plug from the
mains socket.
Only a qualified electrician or compe-
tent person must do the troubleshoot-
ing that is not in this manual.
Problem
The appliance is noisy
The appliance does not
operate. The lamp does
not operate.
The lamp does not work.
The Pilot light flashes.
The compressor oper-
ates continually.
The compressor does
not start immediately af-
ter pressing the Action
Cool button, or after
changing the tempera-
ture.
Water flows on the rear
plate of the refrigerator.
Temperature cannot be
set .
Possible cause
The appliance is not supported
properly
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
The appliance has no power.
There is no voltage in the mains
socket.
The lamp is in stand-by.
The lamp is defective.
The appliance is not working
properly.
The temperature is not set cor-
rectly.
The door is not closed correctly.
The door has been opened too
frequently.
The product temperature is too
high.
The room temperature is too
high.
The compressor starts after a pe-
riod of time.
During the automatic defrosting
process, frost defrosts on the
rear plate.
Schnellkühlen function switched
on.
Important! There are some sounds during
normal use (compressor, refrigerant
circulation).
Check if the appliance stands sta-
ble (all the four feet should be on
the floor)
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical appli-
ance to the mains socket.
Contact a qualified electrician.
Close and open the door.
Refer to "Replacing the lamp".
Contact a qualified electrician.
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open longer
than necessary.
Let the product temperature de-
crease to room temperature be-
fore storage.
Decrease the room temperature.
This is correct.
This is correct.
Switch off Schnellkühlen Action
Coolmanually, or wait to set the
temperature until the function has
reset automatically. Refer to " Ac-
tion Cool function".
Solution