Canton musicbox Air 3 Bedienungsanleitung Seite 39

Actions Problems
general operation of musicbox Air 3 does
musicbox Air 3. not respond.
the leD ring is blink-
ing blue.
Firmware update Your web browser's
over the network returns a "page load
(file name: error", the web con-
musicboxAir3_ figuration page is no
Version_XX.fw). longer displayed.
When attempting to
select the update file,
the error message "in-
valid file" is returned.
Firmware update the musicbox Air 3
over the network does not work any
or uSB (file name: longer, all leDs are
musicboxAir3_ off or the leD ring is
Version_XX.fw). blinking blue.
Possible causes
the musicbox Air 3 has been hung.
the protection circuit of the musicbox
Air 3 has been activated due to an over-
load (e. g. overtemperature or overcur-
rent).
A new iP address was allocated to the
musicbox Air 3 by your network router.
unknown
the update process was interrupted
(e.g. loss of electricity) and the update
could not be completed.
Solutions
2. Reset the musicbox Air 3, if necessary.
Press and hold the ReSet button on
the back until the leD ring is blinking
green rapidly (2x per second).
Switch the musicbox Air 3 into Standby
Mode and wait at least 30 minutes.
Check your network router for the cur-
rent iP address of the musicbox Air 3
and enter this into the browser's address
bar in order to continue with the update
process.
Repeat the procedure as before until it
can be completed.
leave the musicbox Air 3 connected to
the mains for at least 30 minutes. After
this time, try performing a firmware up-
date over the network.
English
39