Dogtra 4500 EDGE Handbuch Seite 32

To replace the battery in the receiver/collar
1. Begin with the receiver/collar turned off.
2. Remove the strap and unscrew the Phillips head screws on the four
corners of the receiver/collar.
* Unscrew the screws with a firm grip, taking extra caution to not strip
the screws.
3. Remove the front case. While holding the battery wire, detach the
wire from the battery connector plug.
4. Holding the battery wire of the new battery, plug the wire in to the
battery connector plug.
5. Check that the battery connector wire is firmly inserted into the plug.
The battery wires must be inside the battery compartment.
60
* Caution - The battery wires must
run neatly along the top left side in
to the battery compartment.
* Caution - Do not detach the wire
by pulling from the battery.
* Caution - The orange rubber
gasket is important for the unit
to be waterproof and must be
properly seated in place.
61