How To Attach The Belt Clip On The 4500 Edge; How To Use The Test Light - Dogtra 4500 EDGE Handbuch

13. HOW TO ATTACH THE BELT CLIP ON THE 4500 EDGE

To attach the included belt clip to the transmitter, follow
the instructions below.
1. Align the belt clip to the grooves on the back of the transmitter.
2. With a firm grip, screw on the belt clip using the provided
Philips head screws.
Tighten until firmly in place. Be careful not to over tighten.
56
* Caution *

14. HOW TO USE THE TEST LIGHT

Test for a stimulation using the included test light.
1. Turn on the receiver/collar and the transmitter and place the test light
over the contact points as shown in the diagram.
2. The test light will illuminate momentarily when the front transmitter
button is pressed on the "N" mode. The light will stay lit as long as
the front transmitter button is pressed on the "C" mode, up to 12
seconds.
* For more information on the "N" and "C" modes, see section 2. How
the buttons work.
3. When the stimulation dial is turned up, the test light will emit a
brighter light.
NOTE: The test light may not emit a visible light when the intensity
level is set below 10. The test light may be difficult to see in
bright light settings.
57