Cleaning And Storage - Clatronic bs 1227 Bedienungsanleitung

4....-05-BS 1227
Damper
GB
Open the damper on the hose handle to adjust the airflow or to release objects clin-
ging to the nozzle.
Dust bag filling display
Hold the hose up into air. If the dust bag change display lights up, the bag is full.
Please change it.
Changing the dust bag
1. Pull the plug out of the socket.
2. Pull up the cover on the recess.
3. Remove the dust bag.
4. Insert a new dust bag.
5. Close the cover so that it snaps into place.
Filter: Your appliance has two filters.
Motor protection filter (inlet filter):
• The inlet filter is located in the dust bag compartment.
• The filter is placed horizontally in the inner part of the dust bag compartment
casing.
• Pull the filter out from the front. Clean the engine protection filter after 10 dust
bag changes. If necessary, the filter can also be washed in warm water without
any additives.
• Place it back into place only once it is completely dry!
Outlet filter:
• The appliance is also equipped with an outlet filter.
• It is located on the rear part of your appliance behind a ventilation grid.
• Open the ventilation grid by pressing the lever on the right side of the ventilation
grid.
• Pull the grid up and out. Remove the filter and clean as described above.
• Fit the filter back into place and close the ventilation grid by following the steps
above in the opposite order.
Please note: When inserting new filters you may have to cut these beforehand to
the appropriate size. Place the old filter on top of the new one, trace the outline and
then cut along the line.
Cleaning
• Pull the plug out of the socket before cleaning!
• Clean the casing with a dry cloth.
36
13.06.2002 8:17 Uhr

Cleaning and storage

Seite 36