Using The Appliance - Clatronic bs 1227 Bedienungsanleitung

4....-05-BS 1227
1. Insert the vacuum hose in the opening in the dust bag compartment until it
locks in mechanically.
2. To release the hose, press the button on the vacuum hose.
3. Keep the button pressed and pull out the hose.
4. Insert the vacuum tube into the handle if required.
1. Fit on the accessory.
2. Unwind the necessary length of cable and insert the plug in a duly installed
230V/50Hz protective contact socket.
3. Set the vacuum power with the vacuum power regulator.
4. Vacuum at a steady speed. There is no need to exert pressure.
5. Attention: pay attention to the range that can be covered with the cable length.
Vacuum power regulator
Low vacuum power:
Medium vacuum power:
High vacuum power:
Cable winding device:
Pull out the cable up to the maximum length indicated with the yellow mark. Never
pull the cable out up to the red mark as the cable winding can be damaged. Said
damages are not covered by the warranty.
Winding
Press the cable winding button and guide the cable. Hold the cable to avoid wrap-
ping.
Nozzle accessories
Crevice nozzle:
Upholstery nozzle:
Floor nozzle:
Please note that the crevice or upholstery nozzles are "2 in 1" attachments. In order
to use the relevant attachment, please press the brush in the direction of the arrow
and push the upholstery nozzle forwards or backwards until it locks in place.
Smooth floors:
Carpets:
Releasing the accessories: Pull them apart while turning slightly.
13.06.2002 8:17 Uhr

Using the Appliance

For curtains and delicate fabrics
For long-pile velour carpets and textile flooring
For sturdy rugs and floors
To vacuum corners and slits
To clean upholstery, curtains, etc.
For cleaning carpets or smooth surfaces.
Press down the lever with the brush symbol with your
foot. The brush is now visible.
Press down the opposite lever.
Seite 35
GB
35