Installation; Unpacking - AEG L 87495 XFL Benutzerinformation

26 www.aeg.com
Problem
The appliance fills
with water and
drain immediately.
The washing re-
sults are not satis-
factory.
After the check, activate the appliance.
The programme continues from the
point of interruption.
If the problem occurs again, contact the
service centre.

17. INSTALLATION

17.1 Unpacking

Possible cause
The end of the drain
hose is too low.
The detergent you used
was not sufficient or cor-
rect.
You did not remove the
stubborn stains before
you wash the laundry.
Incorrect temperature
was set.
Too much laundry load.
Possible solution
Make sure that the drain hose is
in the correct position.
Increase the detergent quantity
or use a different one.
Use special products to remove
the stubborn stains.
Make sure that you set the cor-
rect temperature.
Decrease the laundry load.
If the display shows other alarm codes,
contact the service centre.
1. Use the gloves. Remove the external
film. If necessary, use a cutter.
2. Remove the cardboard top.
3. Remove the polystyrene packaging
materials.