Safety Instructions; Designated Use; Installation, Commissioning And Operation; Operational Safety - Endress+Hauser Ecograph T RSG30 Bedienungsanleitung

Multi Channel Recorder
1

Safety instructions

1.1

Designated use

This device is designed for the electronic acquisition, display, recording, analysis, remote trans-
mission and archiving of analog and digital input signals in non-hazardous areas.
• The device is designed for installation in a panel or a cabinet and may only be operated in an
installed state.
• The manufacturer does not accept liability for damage caused by improper or non-designated
use. The device can cause danger if used improperly or other than intended.
1.2

Installation, commissioning and operation

• The device may only be installed, connected, commissioned and serviced by qualified and
authorized expert staff (e.g. electrical technicians) strictly adhering to the instructions con-
tained in this manual, the applicable norms, legal regulations and certificates (depending on
the application).
• These experts must have read and understood this manual and follow the instructions it con-
tains.
• The device may only be modified or repaired if expressly permitted in the Operating Instruc-
tions.
• Damaged devices which could pose a source of danger may not be put into operation and must
be marked as defective.
• Primarily observe local regulations regarding opening and repairing electrical devices.
1.3

Operational safety

• The device is safely built and tested according to state-of-the-art technology and has left the
factory in perfect condition as regards technical safety. The applicable regulations and Euro-
pean standards have been taken into account.
• Please observe the technical data on the nameplate! The nameplate is on the left-hand side of
the housing.
Desk top version
#
Warning!
• The mains plug must only be inserted into a socket with grounding contact.
• The protective effect must not be removed by an extension lead without ground wire.
• Relay outputs: U(max) = 30 V eff (AC) / 60 V (DC)
Electromagnetic compatibility
The measuring system meets the general safety requirements of IEC 61010 and the EMC
requirements of IEC 61326.
Safety instructions
23