InFocus LitePro 700 Series Installationshandbuch Seite 10

H a n g t h e L i t e P r o o n t h e C e i l i n g
8
Hang the LitePro on the Ceiling
1 Assemble the hinge pin bolts, washers and
spacers to each side of the base box as shown
in Figure 5. Be sure to place the flat side of the
black spacers towards the base box. Do not
tighten the bolts at this time, leave them very
loose.
black spacer
silver washer
hinge pin bolt
F 5
IGURE
Attach hinge pin bolt, washer and spacer to the side of the
base box
2 Carefully lift the projector and turn it upside
down so the mounting plate faces the ceiling.
3 Insert the projector and mounting bracket
into the hinge pin through the slot openings
(Figure 5). Slide the projector bracket forward
until the hinge pin bolts rest fully in the verti-
cal slots and support the projector.
4 Insert the angle locking bolts (6mm slotted
bolts), two on each side of the base box.
Hand-tighten them.
5 Adjust the angle of the projector so that it will
project correctly.
slide projector
bracket here between
the base box and the spacer