BOMANN DU 667 G Bedienungsanleitung Seite 20

NOTE NOTE: : : : Recomm Recommendations for preparation work endations for preparation work endations for preparation work endations for preparation work
NOTE NOTE Recomm Recomm endations for preparation work endations for preparation work endations for preparation work endations for preparation work
• When installing, ask another person
• Wear protective gloves to prevent injuries from any sharp edges. Wear protective gloves to prevent injuries from any sharp edges.
1
4
• Determine the position of the extractor hood centrally above the hob in Determine the position of the extractor hood centrally above the hob in conformance with the
safety distances.
• Mark the necessary holes for the wall mounting by using the supplied drill template and check them with a Mark the necessary holes for the wall mounting by using the supplied drill template and check them with a Mark the necessary holes for the wall mounting by using the supplied drill template and check them with a
spirit level.
• Drill Ø 8 mm mounting holes into
fasten the brackets with the screws
• Attach the suspension rail (1) for
edge parallel to the rail (1) (Fig. A).
• Before suspending the hood:
- the glass capture panel is fastened to the hood body with the screws (7) in the rubber plugs with the glass capture panel is fastened to the hood body with the screws (7) in the rubber plugs with the glass capture panel is fastened to the hood body with the screws (7) in the rubber plugs with
washers (Fig. B).
- insert the non-return valves (4)
For extraction mode: For extraction mode:
For extraction mode: For extraction mode:
• Hereupon a flexible extraction hose (not supplied) with an inner diameter of Ø 150 mm must be attached Hereupon a flexible extraction hose (not supplied) with an inner diameter of Ø 150 mm must be attached Hereupon a flexible extraction hose (not supplied) with an inner diameter of Ø 150 mm must be attached
(Fig. C) and connected to the outside by the extraction outlet. (Fig. C) and connected to the outside by the extraction outlet.
• Hook the extractor hood into the suspension rail (1) (Fig. D). Check that it is secure Hook the extractor hood into the suspension rail (1) (Fig. D). Check that it is secure Hook the extractor hood into the suspension rail (1) (Fig. D). Check that it is secure and horizontally level.
• Remove the protective plastic from the telescopic duct. Remove the protective plastic from the telescopic duct.
• Fix the outer (lower) duct with the mounting rail without the bracket (3). The rail is fastened to the holes
provided from the inside of the duct. Screw in two plate screws (8) from the back (Fig. provided from the inside of the duct.
person to assist.
5
the wall for the respective brackets (1+2+3). Insert
screws (6).
for the hood body as well as the mounting rail with bracket (2) to the top
A). Determine the extension length of the duct cover
(4) onto the extractor duct from above by gently bending
the mounting rail without the bracket (3). The rail is fastened to the holes the mounting rail without the bracket (3). The rail is fastened to the holes
2
6
as well as the mounting rail with bracket (2) to the top
20
3
7
formance with the specified
Insert the dowel pins (5) and
cover in advance!
bending them.
(Fig. E).
8