Outputs - Ecler DP 300 Bedienungsanleitung

8. OUTPUTS

The DP300 has 6 outputs (OUTPUT 1-6), which are differently grouped depending on the operating
mode that has been chosen.
In Mono mode, all 6 outputs operate independently.
In 2 x 3 way mode (2 channels, 3 ways), outputs can be linked together. For that reason, they are
grouped as follows:
Output 1 and 2 (OUT1 &OUT2)
Output 3 and 4 (OUT3 &OUT4)
Output 5 and 6 (OUT5 &OUT6)
In 3 x 2 way mode (Left Centre Right, 2 ways) outputs are grouped as follows:
Output 1 and 3 (OUT1 & OUT3)
Output 2 (OUT2)
Output 4 and 6 (OUT4 & OUT6)
Output 5 (OUT5)
If stereo linking is not desired, set the "Stereo Link" option to Off, so that the parameters of each
channel can be modified independently.
When the outputs are linked together, modifying a certain parameter of one channel automatically
updates the same parameter on the linked channel.
To access the parameters of each output, press the encoder wheel. Once in the screen corresponding
to the output to be configured, NEXT and PREVIOUS brings you to the individual parameters of this
output.
Once the desired parameter has been reached, its value can be modified by turning the encoder wheel
or by using the ? and ? keys.
Each one of the outputs offers following configuration options:
1. Output name.
2. Signal Source.
3. Gain.
4. Limiter.
5. Delay.
6. Delay Link.
7. Polarity.
8. Lower filter slope shape (Lo shape).
9. Lower cut-off frequency (Hi pass).
10. Upper filter slope shape (Hi shape).
11. Upper cut-off frequency (Lo pass).
12. Equalizer.
1. Output Name
Depending on the operation mode, each output is assigned a default name. In general, the outputs 1 to
6 are named Band 1 to Band 6 respectively.
OUT 1&3
Name
Band 1
Band 1
23