Hilti PD 10 Bedienungsanleitung Seite 34

Dear PD10 Customer
The PD10 Laser Range Meter you have purchased
is factory set for measuring in the metric system. If
you would like to change to imperial measurements
(feet and inches) please follow the instructions:
1 Insert the 4 batteries (they can be found in the
side pocket of your canvas pouch)
2 Press
(ON/OFF)
3 Press
(MEN)
4 Press (M+)
4× until
«UNIT m» is shown
5 Press (+)
6 Press (MEN)
again to leave
the menue
This setting is now effective and will not change if
the unit is switches off or if batteries are changed.
To change back to metric measurement please
refer to the user manual pages 51 and 52.
1×
1×
4×
1×
1×
®
314362/5