Interrupting A Gas Alarm With The Wireless Remote Control; Using The Cable Loop (Accessory); Using The Back­up Siren - Thitronik WiPro III Bedienungsanleitung

WiPro III Operating Instructions

1.9.6 Interrupting a gas alarm with the wireless remote control

Any button interrupts the alarm or disarms the system.
If the alarm is triggered when the system is disarmed, any button must be
pressed twice in succession.
It may be necessary to close the cab doors, depending on the vehicle type.
T he vehicle indicators flash once or twice (depending on the vehicle type),
the interior beeper sounds 1 long and 2 short tones (disarmed).
Status LED flashes to indicate the corresponding cause of the alarm (see Page 6).
1.9.7 Using the wireless gas alarm (accessory)
The wireless gas alarm can be switched on or off via the pressure switch on
the narrow side of the casing. After switching on, the power lamp on the front
lights up green. After the cleaning phase has finished, which lasts approx.
4 minutes, the system flashes green and the gas alarm now monitors the room
GB
air for critical concentrations of propane, butane and narcotic gases.
S pray cans (hairspray and deodorants etc.) contain combustible propellants
which can trigger the gas alarm at high concentrations. Even strong cleaning
agents can trigger the gas alarm at high dosages because of the aerosols they
contain. We therefore recommend deactivating the gas alarm when using these
materials.
1.9.8 Using the radio cable loop (accessory)
The radio cable loop can be plugged into the holder when the system is either
armed or disarmed. It can be used to secure bicycles, motor scooters, camping
furniture, surfboards and many other movable objects. Once the cable loop
has been placed in the holder, cutting the cable or removing it from its holder
will trigger the alarm.
1.9.9 Using the back-up siren (accessory)
The back­up siren has an integrated rechargeable battery which is charged
via the vehicle battery. When the system now triggers the alarm, the back­up
siren sounds. The back­up alarm siren will even sound when the supply voltage
has been removed (sabotage alarm).
The back­up siren has a key switch on the back of the unit. Keep the key for it
in a safe place so that the siren can be deactivated for servicing purposes.
Find out from your dealer where he has installed the siren.
Page 5