Klarstein 10008248 Bedienungsanleitung Seite 9

Step 3: Insert the removable tray.
1. Follow assembly procedure.
2. Make sure the popcorn maker is unplugged before you do any of the following.
3. Before using the unit, please check carefully to be sure voltage (AC120V ~60Hz) is suitable for
your home.
4. Clean the internal surface of the kettle with warm soapy water, rinse well and dry with clean cloth.
Wipe down inner and outer housing with damp cloth.
5. Main unit has a 2-function switch as follows:
a. - LIGHT: to turn light on;
b. - POP: to turn motor & heater on.
6. Insert the internal plug into the socket.
7. Plug the power cord into an electric outlet.
8. Before pouring oil or kernels, lift lid up using the lid tab. Turn both LIGHT & POP switches to on
position. The light, heater and motor will be on. Let the kettle preheat about 2 to 3 minutes.
Turn the POP switch to off position and add oil (1 tablespoon of vegetable, corn, peanut, or saff-
lower oil). Immediately add 1/3 cup of corn kernels (Note: 1/3 measuring cup included) and close
the lid of the kettle. Turn POP switch on again, stirrer will begin to rotate and heater will heat up
the kettle. CAUTION: Lid might be hot – it is recommended to use an oven mitt.
9. Popcorn starts popping out through the lid after about 2 minutes.
10. When unit is finished popping – you will no longer hear the corn popping – immediately turn the
POP switch to the off position and pull down the handle bar of the kettle to release any remaining
popcorn from the kettle. This will also stop the remaining popcorn from cooking any further and
avoid possible burning.
11. Keep POP switch off if the unit is not continuously in use.
12. Remove plug from power supply if the unit is not being used.
13. Repeat step 8 to 10 for continuous popping.
9
Step 4: Place the door on hinges.
Popping Instructions