Gas heater
Type DG
Switching on (DG 25 A and DG 45 A)
1. Operation without a room thermostat:
Turn switch E on to "permanent HEATING."
2. Operation with a room thermostat:
Plug the room thermostat into the plug socket G.
As soon as the room thermostat absorbs heat, the device will start on its own.
Attention: If there is any fault, button F will permanently light up red.
Please press button F once to introduce a new attempt to start. You can recognise
operation of the control unit when there is red blinking.
3. You can now set performance with the gas pressure regulator.
Switching off (DG 25 A and DG 45 A)
1. Turn off switch E (bring it to the centre position)
2. Let the device cool before dismantling or transporting it.
3. Shut the gas tap.
E
F
Setting gas pressure/performance
G
24
EN