Beko WSA 29000 Bedienungsanleitung Seite 10

GB
 It is not recommended to stop the appliance
if you will not use it for a few days. If you don't
use it for a longer period, please proceed as
follows:
- unplug the appliance;
- empty the refrigerator and the freezer;
- defrost and clean the appliance;
- let the doors open in order to avoid the
unpleasant odors.
 If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order to
avoid a hazard.
Installation
 The appliance is designed to operate in class
4H2 according to SR EN ISO 23953-2
ambient temperature 30
humidity 55%5% - which should be kept
relatively constant. Assembly the appliance
far from any heat source. Placing the
appliance in a warm room, exposing it directly
to sunshine or placing it near a heat source
(heaters, cookers, ovens) results in energy
consumption increase and reduce the life of
the appliance.
 Please observe the following minimal
distances:
- 100 cm from the cookers with coal or petrol;
- 150 cm from the electric and/or gas cookers
Provide free air circulation around the
appliance, by observing the distances
mentioned in the drawings (Items 2&3).
 Put the back airing lid to the back of your
refrigerator to set the distance between the
refrigerator and the wall (Item 3).
 Place the appliance in a dry and well
ventilated place, perfectly even, adjusting the
front feet if necessary (Item 4).
0 0
C1 ; relative
 Any "suspended" furniture will be assembled
at a minimum distance of 10 cm above the
appliance. The same distance will be also
provided in case of a niche or another
construction element.
 The appliance is not made to be built in the
furniture.
 Please assemble the accessories.
Mains connection
Your appliance is designed to work at a
mono-phase voltage of 220-240V, 50Hz.
Before connecting the appliance to the
mains, be sure that the mains parameters of
your house (voltage, current type, and
frequency) are according to the working
parameters of the appliance.
 The information concerning the supply
tension and absorbed power are given in the
marking label, placed inside on the side,
which can be seen after drawing the crisper.
 The electric installation must be done
according to the law requirements.
 The manufacturer is not responsible for the
eventual problems occurred to persons,
animals or property due to the non-
observance of the above-mentioned
conditions.
 The apliance has a supply cable and a plug
(European type, marked 10/16A), with double
earthing. If the plug is not the same type as
the socket, ask a specialised electrician to
change it.
 Do not use adaptors.
Starting the appliance
Before starting the appliance, clean the inside
of the appliance. (See "Cleaning and care").
After doing this, connect the appliance to the
mains. Adjust the thermostat buttons on an
average position.
For inside lighting, ajust button of the
signalling block on medium position .
Leave the appliance operate abt. 2 hours
without placing inside any beverages or food
inside.
3
Instruction for use