Interfaces; Fig. 3: Location Of The Interfaces And Alignment Controls - Siemens SCD 1297-K Betriebsanleitung

Operating instruction
Thermal Problems
In order that the SCD 1297-K maintains an optimum operating temperature while in use, air
must be allowed to circulate freely around the enclosure. This is especially important for the
rear of the unit. Convection current must be allowed to circulate around the enclosure
Please bear in mind that increased temperatures can lead to defects and to a significant
reduction in the lifetime of the monitor.
EMC Problems
This unit has been designed for building into an industrial system. The operator of the entire
plant is responsible for maintaining electromagnetic compatibility according to EMC laws.
Safety Problems
All voltage and signal connections must adhere to legal requirements.
Ergonomics
The screen should be easily viewable from all sides without reflections.
A high-quality 75-ohm coaxial cable must be used for the VGA signals. Low quality cables
can result in interference and shadowing on the display.
2.3

Interfaces

Fig. 3: Location of the interfaces and alignment controls

Page 43 / 64
Control panel SCD 1297-K DOC-Nr.: b40008de3.doc