Tools Needed For The Assembly; Your 2 Channel Radio System - Carson STREETBREAKER Betriebsanleitung

Tools needed for the assembly

GB
Modelling knife 74053
Philips screwdriver
(small and big)
1,5/ 2 / 2,5 mm 74023
a. Your 2 channel radio system
Please read the instructions provided with your radio system
before using it.
The servos must be set at the centre position before
installation. To set the servos at a neutral position, turn on
the transmitter and receiver. Set the trim levers in the center
position and turn off the receiver, and then the transmitter. The
servos will be in proper neutral position for installation.
Receiver antenna
Engine
throttle
servo
6 CARSON Street Breaker 204017
014671_anl_204017_streetbreaker.indd 6 014671_anl_204017_streetbreaker.indd 6
Instant adhesive 53339
Hexagonal wrench 13118
system
Batteries for receiver
Switch
Steering servo
Needle nose pliers 74034
Tweezers 74003
Transmitter
Scissors 13305
Side cutter 74035
09.08.2010 17:17:59 Uhr 09.08.2010 17:17:59 Uhr