Changing The Select Keys - G&D TradeSwitch8-PS/2 Bedienungsanleitung

Changing the select keys

In the default settings, use the enabled select keys
puters that are connected to the KVM switch.
For instance, you can switch to computer 2 by pressing
How to choose a different select key set:
1. Press Hotkey+Backspace
mode.
If the hotkey delay is active, press the key combination for seven seconds.
2. Press one of the setup keys shown below to activate the desired set of select
keys to switch the computers 1 to 8:
1  Enables select keys 1, 2, 3, 4, 5, 6, 7, 8
 Enables select keys NUM 1, [...],NUM 7, NUM 8
NUM 1
Z  Enables select keys A, B, C, D, E, F, G, H
F1  Enables select keys F1, F2, F3, F4, F5, F6, F7, F8
1. Use the terminal emulator to establish a connection to the KVM switch.
If the setup menu is not displayed, the Switch mode of the service port is
enabled. Enter »
2. Use the
Arrow
3. Press the
Space
switch the computers 1 to 8:
 Enables select keys 1, 2, 3, 4, 5, 6, 7, 8
1 ... 8
NUM 1 ... 8  Enables select keys NUM 1, [...],NUM 7, NUM 8
A ... H  Enables select keys A, B, C, D, E, F, G, H
 Enables select keys F1, F2, F3, F4, F5, F6, F7, F8
F1 ... F8
4. Press the key to save your settings.
S
(default: Alt Gr+Backspace
« to change to the setup menu.
#!
or keys to select the
Arrow
key (repeatedly) to enable the particular set of select keys to
Configuration
to to switch between the com-
1 8
Hotkey+2 (default:
) to enable the setup
row.
Select Key
G&D TradeSwitch8-PS/2 · 18
Alt Gr+2 ).