Binding; Assignment To Underfloor Heating Controller; Assignment To Evotouch; Failed Binding - Honeywell HCW 82 Bedienungsanleitung

Commissioning
2.1.

Binding

2.1.1. Assignment to underfloor heating
controller
In order to assign a temperature zone to the HCW 82/
HCF 82, follow the instructions from the chapter entitled
"Start-up" in the "Underfloor heating controller
HCE 80/HCE 80R/ HCC 80/HCC 80R" installation
instructions.
2.1.2.

Assignment to evotouch

In order to assign a temperature zone to the HCW 82/
HCF 82, follow the instructions of the evotouch.
Press the Bind button to carry out binding.
►
2.1.3.

Failed binding

If the binding has failed:
Improve the data transfer (see below).
►
Repeat the binding procedure.
►
Improving the data transfer
When selecting the operating site of each device ensure
►
that the distance to radio devices such as radio
headphones, cordless phones, etc. according to the DECT
standard amounts to at least 1 m.
Do not install the devices over metallic wall connecting
►
sockets and at least 30 cm away from the cover of the heat
generator.
Correct the installation site of the room temperature sensor
►
if necessary.
8
2.2.

Installation

Remove the batteries.
►
Mark the drill holes according to the drilling template
►
(see Fig. 3).
Fig. 3: Drilling scheme (measurements in mm)
Drill the holes.
►
Screw on the room temperature
►
sensor.
Re-insert the batteries.
►
Place the housing cover in
►
position above and snap it down
(see Fig. 4).
Fig. 4:
Placing housing cover in
position