Adjusting The Fader (Fad); Adjusting The Volume Of The Subwoofer(S) - Sony XR-C900RDS Bedienungsanleitung

5
Press (4) (n).
LP1
R
EQ SUR
6
Rotate the dial to adjust the centre of
the sound field to the front or rear.
7
Press (SOUND) for two seconds.
When the effect setting is complete, the
normal playback mode display appears.

Adjusting the fader (FAD)

Normally, with the DSP mode on, the volume
of the output sound from the rear speakers is
EN
lowered automatically to improve the
efficiency of the listening position setting. If
you want to raise the rear speaker volume,
adjust the fader.
1
Follow steps 1 to 3 of "Selecting a
surround menu" (page 22).
2
Press (SOUND) momentarily until "FAD"
appears.
3
Rotate the dial to adjust the fader.
After three seconds, the display goes back
to the normal playback mode.
Adjusting the volume of
the subwoofer(s)
1
Press (SOURCE) to select a source (radio,
tape, CD, or MD).
2
Press (SOUND) repeatedly until "SUB"
appears.
3
Rotate the dial to adjust the volume.
After three seconds, the display goes back
24
to the normal playback mode.
F
Centre moves to the R (rear)
Centre moves to the F (front)
Decreases front speaker volume
Increases front speaker volume
Adjusting the frequency of the
subwoofer(s)
To match the characteristics of the connected
subwoofer(s), you can cut the unwanted high
and middle frequency signals entering the
subwoofer(s). By setting the cut-off frequency
(see the diagram below), the subwoofer(s) will
output only low frequency signals so that you
can get a clearer sound image.
Cut-off frequency
62 125 198
1
Press (SOURCE) to select a source (radio,
tape, CD, or MD).
2
Press (SOUND) for two seconds.
3
Press (SOUND) repeatedly until "SUB"
appears.
SUB
C.off125Hz
EQ SUR
4
Rotate the dial to select the desired cut-
off frequency.
The cut-off frequency in the display
changes.
5
Press (SOUND) for two seconds.
When the frequency setting is complete, the
display goes back to the normal playback
mode.
Frequency (Hz)