INTUO E 01-K Gebrauchsanleitung Seite 23

GENERAL mAINTENANCE AND
CARE INSTRUCTIoNS FoR FITTINGS
tHe fittings of your kitcHen reQuire little or no care. to assure a long life anD function, tHe
folloWing guiDelines Must be observeD. never use cleansers tHat contain acetone, cHlorinateD
HyDrocarbon, Paint tHinner or solutions tHat begin WitH tHe syllables "tri" or "tetra". tHe above-
MentioneD cleaners sHoulD alWays be storeD tigHtly closeD, since leaking vaPours leaD to cor-
rosion on all Metal surfaces (WHetHer tHese are of stainless steel or any otHer alloy). sPilleD
salts (WHetHer table salt or DisHWasHing salt) as Well as baking PoWDer also corroDe anD Must be
cleaneD uP iMMeDiately.
HINGES
by regularly aDjusting tHe Hinges, one-siDeD stress can be avoiDeD. tHis Prevents PreMature Wear
anD keePs uP tHe aPPearance of tHe lines of fronts. it is not necessary to oil or lubricate tHe Hin-
ges. HoWever, if Wear is aPParent after long use of Hinges tHat Have not been aDjusteD ProPerly, a
bit of silicone grease can be useD.
DRAwERS
tHe DraWers are MaDe of stainless steel sHeeting anD sHoulD only be cleaneD WitH a soft, sligHtly
DaMP clotH anD, if necessary, WitH a bit of DisHWasHing liQuiD. never use cleansers tHat contain
acetone, cHlorinateD HyDrocarbon, Paint tHinner or solutions tHat begin WitH tHe syllables "tri"
or "tetra". tHe above-MentioneD cleaners sHoulD alWays be storeD tigHtly closeD, since leaking
vaPours leaD to corrosion on all Metal surfaces (regarDless of WHetHer tHese are of stainless
steel or anotHer alloy/surface finisHing). sPilleD salts (WHetHer table salt or DisHWasHing salt) as
Well as baking PoWDer also corroDe anD Must be cleaneD uP iMMeDiately.
LARDER UNITS
tHe runners, fraMes anD baskets are MaDe of PoWDer-coateD steel Profiles or closeD anti-sliP
coateD bottoMs anD sHoulD only be cleaneD WitH a soft, sligHtly DaMP clotH anD, if necessary,
WitH a bit of DisHWasHing liQuiD. never use cleansers tHat contain acetone, cHlorinateD HyDrocar-
bon, Paint tHinner or solutions tHat begin WitH tHe syllables "tri" or "tetra". tHe aboveMentioneD
cleaning agents sHoulD alWays be kePt closeD, as vaPour eMitteD can cause corrosion of Metal
surfaces (regarDless of WHetHer tHese are of stainless steel or anotHer alloy/surface finisHing).
sPilleD salts (WHetHer table salt or DisHWasHing salt) as Well as backing PoWDer also corroDe
anD Must be cleaneD uP iMMeDiately. Due to its soliD construction, it is a bit HarDer to oPen tHe
fittings tHan tHose of a DraWer. to ensure tHat tHe fittings of Pull-out units continue to Work
ProPerly, tHey sHoulD alWays be ProtecteD froM getting Dirty (e.g. froM flour, rice, cruMbs, etc.)
an, if necessary, to be cleaneD. in aDDition any oil tHat Has coMe in contact WitH tHe fitting sHoulD
iMMeDiately be reMoveD, since tHe oil WoulD interfere WitH tHe ProPer functioning of tHe runners,
Making it More Difficult to coMPletely Pull out tHe fitting. if tHe runners Work sluggisHly, tHey
sHoulD not be oileD. Pull tHe fitting out coMPletely, so tHat tHe runners are correctly PositioneD
anD Work ProPerly.
044-045 EN