INTUO E 01-K Gebrauchsanleitung Seite 17

wooD FRoNTS
SoLID wooD oR vENEER
AND oILED SURFACES
WooD is a natural anD living Material. Differences in colour anD structure, as Well as Disco-
louration froM ligHt anD sunligHt are attributeD to its naturalness, anD are no grounDs for
coMPlaint. in general veneereD or soliD WooD fronts are easy to clean, since tHey are sealeD
WitH HigH-Quality varnisH. sPots anD sPills Must be reMoveD iMMeDiately before tHey Dry. clean
WitH a sligHtly DaMP cotton clotH. if you WiPe in tHe Direction of tHe WooD grain, tHis cleans
tHe Pores. avoiD resiDue Moisture in tHe grooves, corners anD eDges anD WiPe WitH a soft, Dry
clotH after cleaning. by nature WooD "Works" in extreMely DaMP or Dry air, i.e. in sPite of tHe
carefully aPPlieD varnisH, WooD sWells or sHrinks. keeP tHe rooM conDitions balanceD (45% -
50% HuMiDity).
for cleaning, We recoMMenD neuPol rosa.
oileD surfaces are ManufactureD WitH HigH-Quality oils tHat are also useD for floor finisHing.
HoWever, care Must be taken to only use cleaning agents tHat are sPecifically suitable anD
aPProveD for tHe care of oileD surfaces. Please reMeMber to test sucH agents on an inconsPi-
cuous area (Prior to use)! for tHe care of oileD surfaces 250Ml oil care ProDuct are ProviDeD.
for surfaces soileD froM fooD reMains or greasy fingers We recoMMenD tHe lca universal
cleaning agent ManufactureD by coMPlex. conventional HouseHolD Detergents (DisHWasHing
Detergents, etc.) sHoulD not be useD! very HigHly fat anD oil Dissolving coMPonents act aggres-
sively on oil or Wax surfaces. abrasive or scouring PolisHing agents Must not be eMPloyeD!
you can obtain furtHer inforMation regarDing care anD sPecial oil care ProDucts froM
WWW.coMPlex-farben.at
032-033 EN
furniture PolisH is not suitable for cleaning
WooD fronts. never use cleansers tHat contain
acetone, cHlorinateD HyDrocarbon, Paint tHin-
ner or solutions tHat begin WitH tHe syllabes
"tri" or "tetra".
WHile cooking, Make sure tHat any extra steaM
is extracteD WitH a cooker HooD. in tHe long
run, Heat anD steaM can DaMage aDjacent units,
fronts or eDges, in sPite of tHe use HigH-Quality
Materials anD Meticulous WorkMansHiP. DaMage
tHat is causeD by iMProPer use is not consiDereD
grounDs for coMPlaint.
keeP rooM HuMiDity betWeen 45% anD 50%.